User's Manual

19
General Specification
Increase or decrease the sampling frequency (Range : 0~100)CLOCK
Change the secondary input source.SOURCE
Change the PIP size. (Small, Large)SIZE
Adjust backlight dimming level (Range : 0~100)BACKLIGHT
ADJUST
Change the layout. (Single, PIP, PBP1, PBP2)LAYOUT
PIP
Change the PIP position.POSITION
Swaps the position of the Primary and Secondary images.SWAP
Change the name of a Preset to the Users Name, etcUSER NAME
ENTRY
SETUP
Adjust time until the OSD Menu will disappear after adjusting the menu. (5,
10, 20, 30, 60, 90, 120, 180, 240 seconds)
DURATION
Change the OSD position ( 9 positions )OSD POSITION
Change the OSD language (8 language)LANGUAGE
Changes the all OSD value to factory outgoing status.
RESET SETTINGS
Disable of enable auto source select.
(ON: Searches through all possible input source until an active video source
is found. OFF: Video input is manually selected.)
AUTO SOURCE
SELECT
Keep still the imageFREEZE FRAME
IMAGE
Enlarge the image, move image left and rightZOOM / PAN
Change the image setting. (Preset 1,2 / User 1,2,3)
IMAGE SETTING
Adjust GAMMA value (VIDEO,BYPASS,1.8,2.0,2.2,2.4,2.6,PACS,GAMMA
Increase or decrease the Phase level (Range : 0~100)PHASE
Adjust the displayed size.(0~8)OVER SCAN
Set the sharpness of image (Softest, Soft, Normal, Sharp, Sharpest)FILTER
Adjust the vertical position of the displayed source image. (Range : 0~100)V POSITION
Green balance (Only works with USER mode) (Range : 0~100)GREEN
Red balance (Only works with USER mode) (Range : 0~100)RED
Blue balance (Only works with USER mode) (Range : 0~100)BLUE
Adjust the horizontal position of the displayed source image. (Range : 0~100)H POSITION
Change the image size (Full, Fill aspect, 1:1, Normal, Anamorphic)IMAGE SIZE
Change the color temperature mode ( 6500K, 5600K, USER )MODE
COLOR TEMP
Increase or decrease the contrast (Range : 0~100)CONTRAST
Changes the richness of color (Range : Green 0~50, Red 0~50)COLOR
Changes the tone of color (Range : 0~100)SATURATION
Adjusts the sharpness of video image (Range : 0~100)SHARPNESS
Increase or decrease the brightness (Range : 0~100)BRIGHTNESS
Function DescriptionsSub-menusMenus
5.2.3 YPbPr input source