User's Manual

Document No. D&TQP0302-11(0) Revision No. 01 Page 11 of 22
Pin Signal Assignment Pin Signal Assignment
1 NC 6 NC
2 RS232 RXD 7 NC
3 RS232 TXD 8 NC
4 NC 9 NC
5 GND
6.6 15pin D-Sub(Male, 2row) Connector
Pin Signal Assignment Pin Signal Assignment
1 Speaker ID 1 9 Left Full Range +
2 Speaker ID 0
10 Left Full Range -
3 Center Tweeter + 11 Right Full Range +
4 Center Tweeter - 12 Right Full Range -
5 Center woofer1 + 13 LMNT
6 Center woofer1 - 14 AMP Ground
7 Center woofer2 + 15 Speaker ID 2
8 Center woofer2 -
z This connection is optimized for TANDBERG’s DNAM AMP system, And DNAM Identify the
speaker ID so that output appropriate audio signal to match this monitor’s speaker module.*
z On this monitor the pin1(Speaker ID 1) must be connected to ground by using internal speaker
wiring.
Pin name LMNT Speaker ID 2 Speaker ID 1 Speaker ID 0
Set digit to 1 1 0 1
1 : must be floated
0 : must be tied to circuit ground