User's Manual

FCC Information
This equipment has been tested and found to comply with the limits of a
Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
interference. This monitor can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, it may interfere
with other radio communications equipment. There is no guarantee that
interference will not occur in a particular installation.
If this equipment is found to cause harmful interference to radio or
television reception, the user is encouraged to try to correct the
interference by carrying out one or more of the following measures:
1. Reorient or relocate the receiving antenna.
2. Increase the distance between the color monitor and the subject
of interference.
3. Plug the monitor into a outlet on a different electrical circuit than
\that to which the subject of interference is connected.
4. Consult the dealer or an experienced radio/TV technician for help.
NOTICES TO USER :
This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may
cause undesired operation.
FCC WARNING :
This equipement geneates or uses radio frequency energy. Changes or
modifications to this equipement may cause harmful interference unless
the modifications are expressly approved in the instruction manual. The
user could lose authority to operate this equipment if an unauthorized
change or modification is made.
1. Guidance and manufacturer's declaration - electromagnetic emissions
The FS-L4202D is intended for use in the electromagnetic environment specified below.
The customer or the user of the FS-L2401D should assure that it is used in such an environment.
Electromagnetic environment -guidance
The FS-L4202D uses RF energy only for its internal function.
Therefore, its RF emissions are very low and are not likely to
cause any interference in nearby electronic equipment
FS-L4202D is suitable for use in ail establishments, including
domestic establishments and those directly connected to the
public low-voltage power supply network that supplies buildings
used for domestic purposes
2. Guidance and manufacturer's declaration - electromagnetic immunity
FS-L4202D is intended for use in the electromagnetic environment specified below.
The customer or the user of FS-L4202D should assure that it is used in such an environment.
Complince level
6kV Contact
8kV air
2kV for power supply
lines
1kV for input/output
lines
Emission test
RF Emissions
CISPR 11
RF Emissions
CISPR 11
Harmonic emisions
IEC 61000-3-2
Voltage fluctuations
IEC 61000-3-3
Compliance
Group 1
Class B
D
Complies
Immunity test
Electrostatic
discharge(ESD)
IEC61000-4-2
Electrical fast
transient/burst
IEC 61000-4-4
IEC 60601 Test level
6kV Contact
8kV air
2kV for power supply
lines
1kV for input/output
lines
Electromagnetic environment -guidance
Floors should be wood,concrete or
ceramic tile. If floors are covered with
synthetic material, the relative humidity
should be at least 30%
Mains power quality should be that of a
typical commercial or hospital environment.
English - 1110 - English