User's Manual

English - 98 - English
Servicing
Do not attempt to service the apparatus yourself as opening or
removing covers may expose you to dangerous voltages or other
hazards, and will void the warranty. Refer all servicing to qualified
service personnel.
Unplug the apparatus from its power source and refer servicing to
qualified personnel under the following conditions:
If the power cord or plug is damaged or frayed.
If liquid has been spilled into the apparatus.
If objects have fallen into the apparatus.
If the apparatus has been exposed to rain or moisture
If the apparatus has been subjected to excessive shock by being
dropped.
If the cabinet has been damaged.
If the apparatus seems to be overheated.
If the apparatus emits smoke or abnormal odor.
If the apparatus fails to operate in accordance with the operating
instructions.
Accessories
Use only accessories specified by the manufacturer, or sold with the
apparatus.
This requirement may not be used in the presence of
flammable anesthetics mixture with air, oxygen or nitrous
oxide.
Recycling :
Follow local governing ordinances and recycling plans
regarding the recycling or disposal of this requirement.
Cleaning Instructions :
Follow your hospital protocol for the handling of blood and
body fluids. Clean the display with a diluted mixture of
mild detergent and water. Use a soft towel or swab.
Use of certain cleaning agnts may cause degrandation to
the labels and plastic components of the product.
Consult cleanser manufacturer to see if agent is compatible
with it. Do not allow liquid enter the display.
EEC Safety Compliance:
This display unit meets the requirements of EN-60601-1
so as to conform to the Medical Device Directive
93/42/EEC (general safety information).
This monitor complies to the above standards only when used with
the supplied medical grade power supply.
JWM1150KA2400F04(Ault korea corp.)
The monitor should be powered from a center tapped circuit when
used in the US at voltages over 120 volts. Monitor is intended for
continuous operation.
This display is energized from an external electrical power source
for class 1 equipment. It Is the responsibility of the installer to test
the display's earth ground to verify that it complies with the hospital,
local and nation impedance requirements.