User's Manual

Page | 6
Operator Safety Instructions
For your safety, please read these safety instructions completely before you connect the
equipment to the power source.
The information in this summary is intended for operators.
Carefully observe all warnings, precautions and instructions both on the Apparatus and in these
operating instructions. Retain this manual for future reference.
Water and Moisture
Do not operate the apparatus under or near water - for example near a bathtub, Kitchen sink, or
laundry tub, in a wet basement, near a swimming pool or in other areas with high humidity.
Never install jacks for communication cables in wet locations unless the jack is specifically
designed for wet locations. Do not touch the product with wet hands.
Cleaning
Unplug the apparatus from communication lines, mains power-outlet or any power source before
cleaning or polishing. Do not use liquid cleaners or aerosol cleaners.
Use a lint-free cloth lightly moistened with water for cleaning the exterior of the apparatus.
Ventilation
Do not block any of the ventilation openings of the apparatus. Never cover the slots and openings
with a cloth or other material. Never install the apparatus near heat sources such as radiators,
heat registers, stoves, or other apparatus (including amplifiers) that produce heat.
Do not place the product in direct sunlight or close to a surface directly heated by the sun.
Lightning
Never use this apparatus, or connect/disconnect communication cables or power cables during
lightning storms.
Dust
Do not operate the apparatus in areas with high concentration of dust
Vibration
If possible, do not operate the apparatus in areas with vibration or place it on an unstable surface.
But, little vibration in allowed.
Power Connection and Hazardous Voltage
The product may have hazardous voltage inside. Never attempt to open this product, or any
peripherals connected to the product, where this action requires a tool.
This product should always be powered from an earthed power outlet.
Never connect attached power supply cord to other products.
In case any, parts of the product has visual damage never attempt to connect mains power, or
any other power source, before consulting service personnel. The plug connecting the power cord
to the product serves as the main.
Disconnect device for this equipment. The power cord must always be easily accessible.
Route the power cord so as to avoid it being walked on or pinched by items placed upon or
against it.
Pay particular attention to the plugs, receptacles and the point where the cord exits from the
apparatus.
Do not tug the power cord.