User's Manual

Page | 12
2. RED
Red balance (Only works with USER mode) (Range: 0~100)
3. GREEN
Green balance (Only works with USER mode) (Range: 0~100)
4. BLUE
Blue balance (Only works with USER mode) (Range: 0~100)
IMAGE
1. IMAGE SIZE
Change the image size (Fill aspect, 1:1, Full)
2. H POSITION
Adjust the horizontal position of the displayed source image. (Range: 0~100)
3. V POSITION
Adjust the vertical position of the displayed source image. (Range: 0~100)
4. SHARPNESS
Set the sharpness of image (0 ~ 9)
SETUP
1. AUTO SOURCE SELECT
Disable or enable auto source select.
(ON: Searches through all possible input sources until an active video source is found.
OFF: Video input is manually selected.)
2. OSD COLOR
Adjust the OSD back ground from white opaque to half translucent.
3. OSD POSITION
Change the OSD position (9 positions)
4. DURATION
Adjust time until the OSD Menu will disappear after adjusting the menu.
(5, 10, 20, 30, 60, 90, 120 seconds)
5. RESET SETTINGS
Change to all OSD value to factory outgoing status.
DVI input sources
ADJUST
1. BRIGHTNESS
Increase or decrease the brightness (Range: 0~100)
Use of brightness adjustment limits the dynamic range