SUPER TRAINERTM EZT plus SERIES Electronic Dog Trainer Owner’s Manual 2872 Walnut Hill Lane Dallas, Texas 75229 Tel: (214) 350-9446, (888) LUV-U-DOG Fax: (214) 350-7847 Website: http://www.dtsystems.com E-mail: customerservice@dtsystems.
19
WARRANTY CONT. TABLE OF CONTENTS How the Limited Lifetime Warranty works: • To qualify for the Warranty you must fill out the warranty registration card which came with your system and mail it (with your original sales receipt) to D.T. Systems within 30 days of purchase. • There is no charge for parts or labor for the first year on any of our lifetime warranty products.
INTRODUCTION WARRANTY Congratulations and thank you for purchasing our EZT plus 5000/5002 Super TrainerTM Beeper Training Collar. The EZT series represents the absolute latest technological advancement in the Electronic Dog Training World. It offers MaxxRange™, the industry’s only internally woven antenna in the collar. With up to a one mile range, they are perfect for hunting, basic obedience and professional training.
MAINTENANCE PACKAGE CONTENTS • It is very important to periodically clean your EZT plus Super TrainerTM for maximum performance. Regular cleaning will also lengthen the life of your unit. TM • Clean the EZT plus Super Trainer collar box with lukewarm water and a mild anti-bacterial soap. • Take care to thoroughly clean the space between the electrodes and the belt.
MODEL FEATURES • • • • • • • • • • • • • • • EZT plus 5000, EZT plus 5002 Digital Technology One mile range trainer Beeper/Locator audible from 450 yards away Lightweight, compact collar and transmitter 16 adjustable intensity levels of Momentary (‘Nick’) Stimulation, and Constant Stimulation Gentle Touch System™ Extra Mild Stimulation MAXX-Range™ Invisible, Embedded Collar Antenna Built in safety shut-off Three beeper functions - Locate, Run/Point, Point only Baritone beeper easier to hear and easier on t
TESTING ADJUSTING & POSITIONING YOUR COLLAR FOR PROPER FIT Before testing, make sure that both units are fully charged and the power to the Collar Receiver is “ON”. To Test the Electronic Stimulation: A) Place the tester firmly on the electrodes of the Collar Receiver. B) Set the intensity (note - an intensity level setting of 4 or less might not be enough to light the tester). C) Push either the ‘NICK’ or ‘STIMU’ button.
PARTS & FUNCTIONS - TRANSMITTER BATTERIES All EZT plus Super TrainerTM collars are equipped with rechargeable Nickel Metal Hydride (NiMH) batteries. NiMH batteries are not memory sensitive and do not require depletion before recharging. The batteries come partially charged from the factory. However, it is recommended that you give the battery a full charge (about 12 hours) before the first use. Remember - Always keep batteries away from flammable substances (especially when charging).
PARTS & FUNCTIONS CONT. PARTS & FUNCTIONS - COLLAR Battery Charging Receptacles The battery charging receptacle is located on the side of the Transmitter, and on the side of the Collar Receiver facing the dog’s neck. After charging, always close the jack with the rubber plug to prevent foreign particles from getting inside the unit. Collar Indicator Light When the Collar Receiver is turned on, the RED light will flash steadily once every two seconds to indicate that the unit is active.
PARTS & FUNCTIONS CONT. Intensity Selection Dial The intensity selection dial allows you to choose between sixteen different levels of stimulation, allowing for very precise control. TRAINING INTENSITY LEVEL The first and most important step in training your dog with your EZT Training System is determining the correct Intensity Level to provide the proper training stimulation without over-shocking your dog. To do this place the Collar on the dog’s neck and turn it on.
