EZT PIUS SERIES Electronic Dog Trainer Owner's Manual * EZT plus 5000 EZT plus 5002 c?!!!b 0.7: Systems, Inc.
NOTICE! Awrding to how you use your transmitter, the transmitting range might be much different.
Table of Contents .................................. 3 Introduction............................................ 4 Package Contents ................................. 5 Model Features......................................6 Adjusting and Positioning Your Collar for Proper Fit.......................7 Parts and Functions............................... 8 Batteries ................................................13 Testing................................................... 14 Important Safety Notes ...............
Congratulations and thank you for purchasing our EZT plus 500015002 Super ~ r a i n e rBeeper ~~ Training Collar. The EZT series represents the absolute latest technological advancement in the Electronic Dog Training World. It offers MaxxRangeTM, the industry's only internally woven antenna in the collar. With up to a one mile range, they are perfect for hunting, basic obedience and professional training.
Transmitter Collar Receiver (two for EZT plus 5002) 4" Antenna for the Transmitter Rechargeable Batteries for both the Collar and Transmitter Battery Charger Double Jack Cable for simultaneous charging Test Light Owner's Manual Carrying Case IMPORTANT NOTE: Please read this owner's manual in its entirety before operating this unit. Should you have any questions about our collars or their operation please contact our Customer Service department (see back page for address and phone number information).
EZT plus 5000, EZT plus 5002 Digital Technology One mile range trainer BeeperILocator audible from 450 yards away Lightweight, compact collar and transmitter 16 adjustable intensity levels of Momentary ('Nick') Stimulation, and Constant Stimulation Gentle Touch SystemTMExtra Mild Stimulation MAXX-RangeTMInvisible, Embedded Collar Antenna Built in safety shut-off Three beeper functions - Locate, RunIPoint, Point only Baritone beeper easier to hear and easier on the dog Rechargeable Ni-MH battery system Compl
AUJU~ I ANU a r u 3 I~ AUII~IIU T uun COLLAR FOR PROPER FIT I Proper collar tightness and position are very important to insure safety and correct functioning every time you use the collar. All electronic collars need to bf very snug to work properly electrodes to make good skir contact. If your collar is too loose, the stimulation may not work properly because good skin contact is not being achieved.
Indicator Light Intensity Selection Dial Momentary RunlPoint Button Locate / Constant Stimulation Receptacle Transmitter (EZT 5002 shown)
Beeper Horn Beeper 'Wire B C R LE .D lndicator Light Collar Receiver Turnina the Unit On: Press and hold the OnIOff button on the Collar Receiver. The Red LED lndicator will light solidly for two seconds. Continue holding the Button until the Red light goes off. The unit is now On. The LED lndicator will now flash approximately every two seconds. (Note: The Transmitter is always in a permanent sleep state. It is only On when a button is being pressed, and does not need to be turned off by the user).
i lntensitv Selection Dial he intensity selection dial allows -3u to choose between sixteen fferent levels of stimulation, lowing for very precise control. TRAINING INTENSITY LEVEL The first and most important step in training your dog with your EZT Training System is determining the correct lntensity Level to provide the proper training stimulation without over-shocking your dog. To do this place the Collar on the dog's neck and turn it on.
Transmitter Indicator Light When one of the push button switches on the transmitter are pushed, the RED light will turn on to indicate that the transmitter is being operated. When the battery needs charging the RED light will blink once every 112 second while pushing a button. , Transmitter Antenna Be very careful when screwing the 4" antenna into the transmitter. Hand tighten only. Over tightening could cause damage to the antenna or the antenna mount.
Batterv Chargincl Receptacles The battery charging receptacle is located on the side of the Transmitter, and on the side of the Collar Receiver facing the dog's neck. After charging, always close the jack with the rubber plug to prevent foreign particles from getting inside the unit. Collar Indicator Light When the Collar Receiver is turned on, the RED light will flash steadily once every two seconds to indicate that the unit is active.
All EZT plus Super ~ r a i n e rcollars ~ ~ are equipped with rechargeable Nickel Metal Hydride (NiMH) batteries. NiMH batteries are not memory sensitive and do not require depletion before recharging. The batteries come partially charged from the factory. However, it is recommended that you give the battery a full charge (about 12 hours) before the first use. Remember - Always keep batteries away from flammable substances (especially when charging).
Before testing, make sure that both units are fully charged and the power to the Collar Receiver is "ON". To Test the Electronic Stimulation: A) Place the tester firmly on the electrodes of the Collar Receiver. B) Set the intensity (note - an intensity level setting of 4 or less might not be enough to light the tester). C) Push either the 'NICK' or 'STIMU' button.
Before beginning training your dog should be examined by a veterinarian to assure that your dog is in good health. Never leave your dog unattended with the unit on. - Since no electronic device is perfect, there iq a very slight possibility that your dog may receive an unintentional electric stimulation. Your EZT plus Super ~ r a i n e ris~ a ~ very valuable tool if used correctly.
It is very important to periodically clean your EZT plus Super ~ r a i n e for r~~ maximum performance. Regular cleaning will also lengthen the life of your unit. Clean the EZT plus Super ~ r a i n e r collar ~ ~ box with lukewarm water and a mild anti-bacterial soap. Take care to thoroughly clean the space between the electrodes and the belt. The belt and buckle should be cleaned with water and a mild soap then allowed to dry completely. Always allow the entire unit to completely dry before using.
D.T. Systems Premium Lifetime Warranty is the best warranty offered in the industry. This warranty is free to participating U.S. customers. (The warranty registration card must be returned within 30 days of original purchase). This changes our normal one year parts and labor warranty to a lifetime warranty against manufacturing defects on parts and a one year warranty on labor. What is covered: D.T.
How the Limited Lifetime Warrantv works: To qualify for the Warranty you must fill out the warranty registration card which came with your system and mail it (with your original sales receipt) to D.T. Systems within 30 days of purchase. There is no charge for parts or labor for the first year on any of our lifetime warranty products.
D.T. Systems, Inc. 2872 Walnut Hill Lane Dallas, Texas 75229 Tel: (214) 350-9446, (888) LUV-U-DOG Fax: (214) 350-7847 Website: http://www.dtsystems.com E-mail: customerservice@dtsystems.
