Owner`s manual

These directions are for initial Programming of a new

Launcher, Programming after battery replacement, and

Programming additional Launchers to the Transmitter.

PROGRAMMING RECEIVER/TRANSMITTER

Programming

1. Verify that the Remote Receiver is off.

2. Choose a number (1-16) on the Launcher Selector Knob

of the Transmitter (optional: label the Launcher with the

number for easy recognition).

3. Push and hold the red Power Button on the Remote Re-

ceiver on the RDL Launcher unit. Do not release the

Power Button.

4. After approximately 6 seconds of holding the Power But-

ton down, the Red LED light will flash 4 times.

5. While continuing to hold the red Power Button down,

push either the “BIRD/NICK” button or the

“BEEPER/CONT” button on the Transmitter for approxi-

mately one second.

6. To indicate the unit has been programmed, the LED light

on the Remote Receiver will flash 5 times and the

Beeper/Locator horn will beep 5 times.

7. After programming confirmation, release the Power But-

ton on the Remote Receiver.

NOTE - Do not release the red Power Button until instructed

to do so or the entire process will have to be repeated. Re-

peat the process from the beginning if the light does not

blink 5 times and beep 5 times at the end of the program-

ming.

WARNING - Do not Program unit while Launcher is

loaded with a Power Load.