Owner`s manual

TESTING
NOTE: Before testing, make sure that both units are fully
charged and the power to the Collar Receiver
is "ON".
To Test the Electronic Stimulation:
1. Place the tester firmly on the
contacts of the Collar Receiver.
2. Set the intensity (note - an intensity
level setting of 4 or less might not be
enough to light the tester).
3. Push the 'NICK' or 'CONT' button.
4. The tester light will quickly flash once when the
Nick button
is pushed and light repeatedly when the
Continuous Stimulation button
is pushed (the test
light will be brighter at higher intensity levels).
To Test the Vibration:
1. Hold the Collar Unit in your hand (make sure the
intensity level is turned all the way down and avoid
touching the metal contacts to prevent accidental
electrical stimulation).
2. Press the red Vibration button on the side of the
transmitter.
3. The Collar Unit should vibrate while the button is
being pressed.
NOTE: If the collar unit is not responding to any signals
rom the transmitter, the collar may need to be repro-
grammed to the transmitter (see
page 14).
13