Owner`s manual

· TURNING ON AND OFF
The Transmitter is always in a permanent sleep state.
It is only ON when a button is being pressed and does
not need to
be turned off by the user.
r----"Tl:I'l"I!~n
Turning the Collar Unit On:
Hold the Red Mark (Magnet
Indicator)
on the left side of the
transmitter directly against the
Red
Mark
(Magnetic Switch Indicator) on
the front of the collar receiver. The
Red LED Indicator will light solid for a second.
Remove the transmitter from the collar unit when the
LED light begins to flash. The unit is now ON, and the
LED light will flash approximately every two seconds.
Turning the Collar Unit Off:
Hold the Red Mark (Magnet Indicator) on the left side
of the transmitter directly against the Red Mark
(Magnetic Switch Indicator) on the front of the collar
receiver. The Red LED Indicator will light solid for a
second. Remove the transmitter from the collar unit
when the LED light begins to flash. The unit
is now
OFF, and the LED will no longer flash.
NOTE
If the Red LED light on the collar unit flashes rapidly while
ON, the unit will need to
be recharged. If the Red LED light
iflashes rapidly soon after a full charging session, the re-
chargeable batteries may need to be replaced. If the Red
LED light on the transmitter flashes rapidly after any button
is pressed, the 9-volt battery may need
to be replaced.
12