Owner`s manual

TESTING
NOTE: Before testing, make sure that both units are fully
charged and the power to the Collar Receiver is "ON".
To Test the Electronic Stimulation:
A)
Place the tester firmly on the
contacts of the
Collar Receiver.
B)
Set the intensity (note - an intensity
level setting of 4 or less might not be
enough to light the tester).
C) Push the 'NICK' or 'CONT' button.
D) The tester
light will quickly flash once when the
Nick button is pushed and
light repeatedly when the
Continuous Stimulation button is pushed (the test
light will be brighter at higher intensity levels).
To Test the Vibration:
(H
2
0 1820 PLUS only)
A) Press the button on the
left side of the transmitter
(Vibrate button) and the
collar unit will vibrate only.
B) Press the button on the right side of the transmitter
(Vib. +Stim. Button) and the unit will vibrate only for
1/2 a second. The tester will then light while vi-
brating at the same time.
To Test the Jump:
(H
2
0 1830 PLUS only)
A) Press the button on the
left side of the transmitter
(Jump button) and test light brightness will reflect
the user-programmed Jump level (see page 19).
B) The intensity level will return to its original setting
when the Jump button is released.
14