Owner`s manual

To Test the Vibration:

(H20

182011 82211 823

only)

Follow the directions for testing the Electronic

Stimulation, and press the button on the left side

of the transmitter.

B) If you press the button on the right side of the

transmitter, the unit should vibrate for

112 second

and then the tester should light while vibrating at

the same time.

To Test the Beeper:

(H20

185011 85211 853

only)

Press the button located on the left side of the

transmitter (Locate button). The collar should

beep any time this button is pressed.

B) Press the button on the right side of the transmitter

(RunlPoint button) to activate the RunlPoint Mode.

Press the button again to change to Point only

mode. In the

RunlPoint mode, the collar should

beep every 4-5 seconds while your dog is on the

run, and every 1-2 seconds when your dog is on

point.

In the Point only mode, the collar will beep

only when your dog is on point. You can shake

the collar to simulate your dog on the run. Press

the 'Locate' button to cancel these modes.