Owner`s manual

Transmitter Indicator Light

When one of the push button switches on the transmitter

are pushed, the RED light will turn on to indicate that the

transmitter is being operated. When the

battery needs charging the RED light will blink once

Two or Three Dog Model Selection Switch

(EZT 1002, 1003, 2002, 2003, & 3002)

Switching between units can be controlled by moving the

toggle selection switch to the desired unit.

PARTS & FUNCTIONS CONT.

Transmitter Antenna

Be very careful when screwing the 2” antenna into the

transmitter. Hand tighten only. Over tightening could

cause damage to the antenna or the antenna mount.

Battery Charging

Jack - Transmitter

The battery charging jack is located on the side of the

transmitter. After charging is complete always close the

jack with the rubber plug to prevent foreign particles from

getting inside the unit.

Remote Training Buttons

Pressing the upper button causes the collar to administer a

Momentary Stimulation or “Nick”. Pressing the lower

button gives the Continuous Stimulation

(Vibration on EZT

3000).