Owner`s manual

Press and hold the Power button on the Collar Receiver.
The red
LED light on the collar will flash 7 times and then
stay on solid.
You must hold down the power button until
the LED light becomes solid. Simultaneously press and
release the "NICK and "STIMU." buttons. In a few sec-
onds, you will see the LED light blink
3 times. The collar
ID is now programmed, and the collar receiver is now
ON.
It is very important to periodically clean your
SUPER PRO
@UTE TRAINERTM for maximum
performance. Regular cleaning will also lengthen the life
of your unit.
Clean the SUPER PRO @LITE TRAINERTMcollar box
with lukewarm water and a mild anti-bacterial soap.
Take care to thoroughly clean the space between the
electrodes and the belt.
The belt and buckle should be cleaned with water and a
mild soap then allowed to dry completely.
Always allow the entire unit to completely dry before
using.