User manual

2.12.b. two track C
This jack is a stereo input for returning stereo machine
C, which could be a DAT machine, CD player, or cassette
recorder for playback (switchable on master section). The
mating plug is a 1/4" stereo plug, tip is left, ring is
right, and sleeve is ground for both. Level setting with
internal jumper +4dBu or -lOdBv.
2.13.a.b. master inserts
These 2 jacks are devoted to the master left and
right inserts. The level is OdBu. These 2 inserts are
provided to insert limiters, aural exciters, or other
stereo devices into the stereo mix immediately before the
master faders.
2.14.a. 2 track A
This jack is a stereo input for returning stereo machine
A, which could be a stereo mastering machine, DAT
machine, CD player, or cassette recorder for playback
(switchable on master section). The mating plug is a 1/4"
stereo plug, tip is left, ring is right, and sleeve is
ground for both. Level only +4dBu for professional master
machines.
2.14.b. alt
This alternate monitor output is for sending the
stereo signal out to a separate power amp for small
speakers such as Auratones. The alt switch on the master
will switch between the small and large speakers (outputs to
two stereo amps).
Nominal level is +4dBu. Tip is left, ring is right, and
sleeve is ground for both.
2.15 C.R.M.
This is the stereo output of the Control Room Monitor and
is used to drive the inputs of a power amp for your control
room monitor speakers. Nominal level is +4dBu. Tip is
left, ring is right, and sleeve is ground for both. Do
not plug 8 ohm headphones into this output. You may use
only those with a 600 ohm impedance or above.
2.16 power
The DAYNER is powered from an external heavy duty
power supply. The supply voltages of +/- 18 Volt and +48
Volt are fused on the front panel of the power supply.
The master section has three LED indicators when the
voltages are present. The power supply is connected to the
console via a 5 pin XLR type connector. This connector is
only used with 21, 31 or 42 frame sizes. The 59 and 84
frames have power connectors mounted on the backside of the
frame.
2.17 Ground post
This is the main ground post for the entire console.
8