User manual

TAPE RETURN is used for plugging the output of your
multitrack tape machine or the outputs of any effects such
as digital delays, digital reverbs, aural exciters, etc.
this track or effect will now appear in the monitor section
if the tape switch is down. If you push down the remix
switch, this track or effect will now appear in the channel
and be controlled by the channel fader. The microphone input
or line input will now appear in the monitor section of the
same module. This will be controlled by the monitor pot and
panned onto the stereo mix buss. This allows you to mix two
signals completely independent of each other on the same
module.
8.6 Connecting the Split Module
Description Connector
Mic Input Balanced XLR
Connect
Line Input
1/4" Stereo Jack
Pin 1
Pin 2
Pin 3
Tip
Ring
Sleeve
Shield
Hot +
Com -
Hot
N/C
Ground
NOTE: With special orders, we can increase the pad to 30dB
and the impedance as well, to provide for, switched
balanced mic/balanced line inputs.
Channel Insert level: OdB Tip
Ring
Sleeve
Return
Send
Ground
Group Insert
Output
Level OdB
1/4" Stereo Jack
Tip
Ring
Sleeve
Tip
Ring
Sleeve
Return
Send
Ground
-lOdBv
+4dBu
Ground
8.7 Connecting the Master Module
Aux outputs: level : +4dBu
Inserts:
level : OdB
tip : +hot
ring : no connection
sleeve : signal ground
tip : return
ring : send
sleeve : signal ground
36