User manual

3 . f. low

The low control has a shelving characteristic just like the

high (3.a) control. 16dB of boost or cut is available at

60Hz. (Boost or cut of all frequencies below 60Hz).

NOTE: The eq. section can be easily modified to increase or

decrease the frequency range of each band to best suit your

individual needs. Contact the D&R Customer Support

Department for details.

3.g. eq on

The equalizer section can be switched in or out for

comparing equalized or unequalized signals.

4 Auxiliary Section

There are 5 aux send controls and 8 aux busses. The

following paragraphs will describe the use of this

section. The 8 master gain controls (for all 8 aux busses)

are located in the master section.

4.a.b.c. aux 1,2, and post

Auxiliary sends 1 and 2 are normally pre-fader but can be

switched post-fader if desired. They are intended to be used

as stereo headphone sends during the recording session and

effect sends in the remix or virtual tracking session.

These aux sends are wired post EQ, post insertion point,

and post channel mute. In a live sound situation, these aux

sends could be used as stage monitor feeds.

4.d.e. aux 3/4

Aux send 3 is normally wired post-fader on the P.CB. but

can be changed easily by rerouting the associated zero ohm

resistors. This option is available from D&R, however, if

you choose to perform this modification, please contact the

D&R Customer Support Department for assistance. The output

of Aux send 3 can be routed to aux send buss 4 by pushing

the associated push-button (4 e). Aux buss 4 is also

post-fader wired.

4.f.g.h.i. aux 5-8

Aux sends 5 through 8 are exactly the same as Aux send 3

and 4 in wiring and possibilities. All normally post-fader

but easily changeable to pre-fader.