User manual

5 Monitor Section

5.a. aux to channel

This switch will allow all aux sends to get their signal

from the channel fader, except those who are permanently set

with the jumper settings.

5.b. tape

This switch will choose from where the monitor gets

it's signal. In the up position (source), the channel

fader feeds the monitor and in the down position (tape),

the tape return feeds the monitor.

5.c. pan

This control will pan the signal in the monitor

section between the left/right stereo image on the stereo

mix buss.

5.d. mute

This switch will turn the monitor section off on that

module.

5.e. solo

This switch will allow you to hear only the signal in

the monitor section. Depending upon what position the

"channel to pfl mode" switch (located in the master

section) is in, you may hear the signal mono pre fade

(monitor level) listen or stereo in place following the

panpot.

5.f. mon (monitor)

This controls the volume in the monitor section of

that channel. It gets it's signal depending on what

position the tape switch is in. In the up position

(source), the channel fader feeds the monitor and in the

down position (tape), the tape return feeds the monitor.

5.g. fdr/rev (fader reverse)

This switch will allow you to swap places with the

channel fader and the monitor pot. In the down position,

the channel fader controls the monitor section and

the monitor pot controls the output of the channel to

the direct out or summed output to the multitrack. Now

those producers can play with the faders without affecting

the signal going to the tape machine. This feature is

also useful when you need fader control on something in the

monitor section at the same time fader control was not

needed on what is in the channel.