User manual

3.4 Aux Send Section
3.4.a. aux 1-2
The top control is aux send 1 and bottom control is aux
send 2. This pair of aux sends are most commonly used
for cue sends (stereo headphones), top control being
left or cue 1 and bottom control being right or cue 2.
Aux sends 1 and 2 can be used as effect sends in the mixing
session.
3.4.b. post:
This switch allows you to choose from where aux 1 and 2
get their signal. In the up position (pre) the signal
comes from before the fader and in the down position
(post) the signal comes from after the fader. It's a good
idea to use the pre position when using aux 1 and 2 for cue
or headphones so when changing the monitor levels you
won't affect the headphone mix.
3.4.C. aux 3-4:
Aux 3-4 can be used as effect sends or as two separate
independent mixes or a stereo mix for headphones. Standard
from the factory, these aux sends get their signal from the
monitor section, however, you can switch them to the channel
by the "aux to channel" switch (3.5.a.) and you can change
permanently from the monitor section to the prefade channel
or the postfade channel with solderless jumpers on the
circuit board.
3.4.d. aux 5-6:
Aux 5-6 is identical to aux 3-4, only they are switchable
to the aux 7-8 busses.
3.4.e. 7-8
When you activate this switch, you move the
concentric aux 5/6 controls (double controls) from feeding
aux busses 5 & 6 or aux busses 7 & 8.
13