User manual

A I R E N C E - U S B M a n u a l P a g e 7
AIRENCE MAIN UNIT TRIPLE INPUT USB MODULES 1-4
INPUT CONNECTORS
-
ule.
The stereo line input uses Cinch female type connectors.
Being un-balanced, the shield and (-) or out of phase signal wire need to

In order to use the START switch, it requires two pins in the ¼” stereo con-
nector located on the back panel to be wired.
-
vated. Once you have done this, a quick start turntable can be started via

-
tor is wired on the back panel.
If your turntable only needs a pulse to start, ask your dealer. Or if you

can be used as a pulse start switch.

uncertain.
*NEVER CONNECT AC POWER VOLTAGE TO THIS REMOTE-JACK*


INSERT






Now insert the stereo jack into the AIRENCE’s insert and connect

-
cessors output. The other mono jack should be inserted into the
processors input.


other and connect to ground (sleeve), this also goes for the other Male XLR, connect the ring of the stereo jack (which sends
signals) to a male XLR pin2. Short here pin 1 and 3 and solder to ground (sleeve). This has to be done because the insert is not
balanced.
See below the cable type you need.
MICROPHONE INPUT

below that should go into your mixer and your mic cable should end in a male

1=Ground/shield
2=Hot (in phase)
3=Cold (out of Phase).