User manual
A I R E N C E - U S B M a n u a l P a g e 3
INTRODUCTION MAIN MIXER UNIT
its own power supply and its own low noise summing amps.
USB Module 1-4
• 4x Professional extremely low noise balanced Mic pre-amps with 48 volt phantom powering.
• Two pairs of line inputs Line and USB.
• Gain control with pre MIC trimmer.
• Three band stereo very musical equalizer.
•
• Stereo Aux send.
• Stereo CUE switch for pre fade listening + CONTROL.
• ON (incl. start switch, when fader is up) + CONTROL.
• 100 mm professional K-Alps fader with fader start.
TELCO-1 and 2 Module
• 2 switchable Telephone-Line inputs.
•
• Gain control for incoming signal.
• Large CONNECTION and TALKBACK switches.
•
• Stereo Aux send.
• Stereo CUE switch for pre-fade listening.
• ON (start switch).
• 100 mm professional K-Alps fader with fader start.
MASTER SECTION
• 2 Long throw K-ALPS master faders.
• Master controls for AUX/SUB/STUDIO/PHONES/ANNOUNCER.
•
• PROGRAM mono switch.
• AUX RETURN to CUE/SUB/PROG.
•
• RECORD OUT fed from PROGRAM/SUB/AUX.
•
• BUILT IN TALKBACK MIC routable to SUB/AUX/STUDIO/ANNOUNCER.
• NON-STOP switch routes one of the 4 USB stereo inputs directly to the main pro-
gram XLR connectors.
AIRENCE EXTENDER UNIT
All triple Input Modules have the following features
• Professional low noise balanced Mic pre-amp with 48 volt phantom powering.
•
• Gain control with pre MIC trimmer.
• Three band stereo equalizer.
•
• Stereo Aux send.
• Stereo CUE switch for pre fade listening.
• ON (including start switch, when fader is up.
• 100mm professional K-Alps fader with fader start.
• Possibility to connect a Studio Remote unit with “Cough Mute” and CUE “Communi-
• Two MIC ON busses to separately control the Control Room and/or Studio mute.
-
trol linking to the main unit and a second Sub-D chassis connector for audio/control linking to a third Extender unit.
Every AIRENCE EXTender unit will be supplied with 1 meter audio extender cable and a power supply that can accept an
AC voltage between 90-230 volts at 50/60 Hz.