User manual
A I R E N C E - U S B M a n u a l P a g e 22
SET-UP ROUTINES MODULE 1-4
•
•
• Connect a microphone or line level equipment.
• Now, connect turntables, CD players, and jingle machines.
•
• The Studio and Announcer outputs can feed high impedance (400 ohms and above) stereo headphones directly.
•
• Now with everything connected, follow the adjustment procedure.
•
upper switch in the module.
•
• Set all the gain-controls and the master faders to its minimum.
•
•
•
SETTING UP AN INPUT CHANNEL
Push the CUE switch in a channel that is connected to a source.
the GAIN control knob could be trimmed for more or less gain.
It is calibrated to indicate 0 dB on the scale corresponding with a +6 dBu output level.
Release the CUE switch so the led bar can now read the output signal again.
The other inputs are similarly adjusted, using the “CUE” switches to (pre fade) listen to the connected sources.
with.
Be carefully not to place the AIRENCE near heavy power transformers such as power amps.
Although the AIRENCE is constructed using a thick metal frame, this could cause hum.
SETTING UP THE USB MODULES
cable from a local computer shop. (See picture).
(PC or Mac) will recognize the
audio programs needing audio hardware.
sequence of 1 to 4.
USB cable to your Windows or Mac computer and start tracking/
playing!
If you are already familiar with digital audio recording, the latest
versions of Kristal Audio Engine and Audacity are available free of
third party downloads.