User manual

A I R E N C E - U S B M a n u a l P a g e 21
MASTER OUTPUTS
The master outputs are 3 pin male XLR connectors and are electronically balanced and can be connected to an input of a power
amp, professional recorder or On-Air processor. The output level is +6 dBu (1.55 volt).
POWER CONNECTOR
These two 5 pin XLR connectors accept external 36 volt 5A switched low energy power supplies that are part of the delivery.
DO NOT USE ANY OTHER POWER SUPPLY THEN THIS ONE!!!
Your AIRENCE can accept voltages between 90 AND 230 volts at 50/60Hz.
The main unit of the AIRENCE works perfectly on one external power supply unit, but incase redundancy is requested, a second
unit can be connected to the second power XLR connector. If one fails the other takes over.
SUB-D CONNECTOR TO SLAVE UNITS
The AIRENCE has a Sub-D connector where you can connect an input slave unit with 6 triple inputs to extend the number of
inputs of your system. All (ON-AIR) and CUE control signals are sent also through this low impedance module link.

