User manual

A I R E N C E - U S B M a n u a l P a g e 19
MASTER BACKPANEL CONNECTORS
The master connector panel houses 18 RCA/Cinch connectors, 2 jack sockets, and 2 male XLR connectors.
There are two power supply connectors, USB connector and the SUB-D type connector to connect a slave unit to the main unit.

AUX SEND
The aux outputs are on two RCA Cinch connec-
tors with the signal coming from the aux send
controls in the channels.
The level is +6 dBu (1.55 volt).
You can connect the inputs of reverbs from
these outputs (with Aux send jumpered to post

you jumper the Aux send in the channels to pre
fader.
CRM SEND
The CRM (Control Room Monitor) outputs
are on two RCA Cinch connectors carrying the
-


PROGRAM SEND


USB inputs.
This non switched output can be used for recording when the console is in its NON STOP mode. The Prog output connectors are

-10dBv (-7.8dBu / 300mV), the signal is post master fader.
AUX RETURN

master main mix busses. You can connect reverb returns or other stereo signals without using any input modules. The input level
should be at least -10dBV.
EXT(ERNAL) INPUTS

The input level should be at least -10dBV.
CUE SEND
The CUE outputs are on two RCA Cinch connectors with the signal coming from the CUE mix busses to be send to a separate CUE
loudspeaker.
The level is +0 dBu (0.775 volt).
STUDIO LEFT RIGHT



RECORD OUT

to from SUB or from AUX. Output level is -10dBV (-7.8dBu / 300mV)
SUB OUTPUTS
The SUB outputs are on two RCA Cinch connectors carrying the signal coming from the SUB summing amps.
This non switched output can be used for recording when the console is in its NON STOP mode, or for sending out channel se-
lected signals.
