User manual
A I R E N C E - U S B M a n u a l P a g e 18
TALK BACK
-
ing switches, you can communicate to the outputs SUB/AUX/STUDIO and An-
when not wanted.
in Electret mic directly to the caller. If an announcer who wants to talk to the
-
the caller’s CUE and now both can talk with each other.
MASTER FADERS
signals. They are conveniently placed close to each other to control both levels
PHONES
switches
between Main Program outputs and CUE from any input module
is heard
We advise you to use headphones with an input impedance NO LOWER THAN
due to the fact that the impedance load is too low. If you must use 8-32 ohm
phones, a small power amp should be used to power the phones. It is a load
equivalent to the load that loudspeakers normally present to power amps. The
AIRENCE has no power-amp built in, sorry.
NONSTOP
mixer while NON STOP on-air.
its signal directly to the main XLR outputs, making your mixer completely free
METERING
-
Be sure to have access to the Internet.
output, the other big meter shows the SUB output
level and the smaller meter on the right hand side