User manual

A I R E N C E - U S B M a n u a l P a g e 17
STUDIO


caller outside a broadcast. You can connect the inputs of reverbs from these outputs (with Aux send jumpered to post fader) or

FOLLOW PHONES
This switch is an input selector for the STUDIO output. Instead of listening to the main
outputs, it allows the user to listen to the phones output. This feature is used by an-

Mute by Mic
This latching switch (when pushed down) allows control signals (mic on) coming from
the DJ mic to mute the CRM speakers.
This is to avoid signal feedback in the studio area and keeps the DJ’s sound clear. At the


ANNOUNCER
The AIRENCE has a separate Announcer output that normally follows the Program


FOLLOW PHONES
This switch is an input selector for the announcer output. Instead of listening to the
main outputs, it allows the user to listen to the phones output. This feature is used by


CRM SECTION (Control Room Monitor)
The CRM control is fed by the master outputs pre (before) the masterfaders.
This can be used as an extra stereo output for recording or a sound system in which
you do not want the master faders to change the out-going signal.
Mute by Mic
This latching switch (when pushed down) allows control signals (mic on) coming from
the DJ mic to mute the CRM monitor speakers. This is to avoid signal feedback in the

which is connected to the Red Light output connector. A jumper in the mic channel
needs to be set to allow this control signal to Mute the Control Room Monitors.
FOLLOW PHONES
This switch is an input selector for the CRM output. Instead of listening to the main outputs, it allows the user to listen to the
phones output. This feature is used by announcers and DJ’s that do not want to use headphones.
BALANCE
The balance knob controls the balance between the main stereo Program output and the stereo Cue signal when selected.
With the balance control anywhere between Cue and L/R you always have control over the main output signal even when a Cue


SPLIT

-
