User manual

A I R E N C E - U S B M a n u a l P a g e 16
AIRENCE MASTER SECTION


LEDBAR METERS

Depending on which switch is pressed (CUE on channels, AUX SEND master, SUB, AUX RET,
EXT, etc.), the master meters will allow the reading of all input and outgoing signals. The

-
ally a red led on is no problem. The output of your AIRENCE-USB is +6dBu (1.55v) (“0” VU)
-
ed display levels.
PROGRAM MONO SWITCH
This switch turns the stereo signal into mono for both main outputs. Using this switch is a

as checking the overall Phase response. Also when one side of the stereo signal is not avail-
able, the mono switch directs the mono signal to both outputs.
EXTERN INPUT
-



RECORD OUTPUT (Rec Out)
The AIRENCE has a Record output on Cinch connectors. These outputs can be fed from SUB

these outputs.
AUX SEND

signals coming from the input channels.

AUX CUE
The AUX SEND CUE switch allows for the master LED bar meters to display the Aux output signal of the Aux master as well as
listening to the signal from the AUX buss. It is necessary to turn the AUX SEND master control up to be able to create and show
an outgoing AUX signal.
AUX RETURN

Program and SUB bus. It can also be used to connect the output of other mixers so you don’t use input channels.
CUE AUX RETURN
This switch enables you to listen to an incoming Aux return signal before the AUX RET (Return) control pot.
SUB SEND

