Specifications

AIRMATE-USB manual page: 9
AUX SEND
Below the TB switch there is the stereo Aux send that can be set to send stereo source signals pre or post
fader by jumper settings. The factory default is post fader.
RING (LED)
This Led lights when a call comes in to alert you.
CUE
Below the equalizer you see the stereo CUE switch (Pre Fader Listening), this switch gives you the possibility
to check the signal before you mix it with your other signals .
ON
The ON switch is used to activate the module and generate a signal to start turntables and CD players as
well as jingle machines. This switch send out a momentary pulse or switches continuously to the Start
connector on the back of the console. In case of the Hybrid module any other function you think is worth
happening can be activated.
FADER
Final control is the 100mm channel fader, this is the actual control to mix the input signals.
All channels have long throw 100mm stereo faders.
At the beginning of the fader movement you will feel an internally built in start switch that is activated when
you bring up the fader. This switch activates the start circuitry, it can control externally connected (via the
Start Connector on the back) devices such as CD players etc.
INPUT CONNECTORS
On the back of your AIRMATE-TELCO module 7 and 8 you
find five connectors.
Two unbalanced stereo line Cinch connectors for connecting
CD players or a play-out system. Any line level equipment
can be connected here.
The level can be set by the gain control to match nearly
every source level.
One cinch connector is the left input and the other Cinch
connector is the right input.
The shield needs to be connected to the ground.
The START switch has two active connections to be wired.
The tip and ring are shorted when the ON switch or fader
switch is activated.
Once you have made this connection to your CD player, you
can start the CD player with the ON switch on the front
panel (or with the fader when the On switch is on).
These switches quick start CD/turntables through the
remote jack by a continuous contact action at the back of
the mixer. If your CD/turntable only needs a pulse to start
ask your dealer to modify the internal circuitry to change it
into a momentary action, so you can use it as a pulse start
switch.
The two RJ11 connectors are there to connect the Module to the companies phone line connection (Wall) and
to connect your telephone appliance (Phone) to be able to dial listeners.
Connections on the START connector can only be made with a maximum of 24 Volts by 50
mA.
Please contact your dealer in case of doubt.
*NEVER CONNECT THE MAINS TO THIS REMOTE-JACK*