User's Manual

DOT400 User Guide -

Connecting to Your Desktop PC Using the

USB Sync Cable or Docking Cradle

Connect your DOT 400 to a desktop PC using the USB sync cable or

docking cradle. USB Driver will be installed automatically. Then, The

synchronization between your device and the desktop PC will start

after establishing a partnership. The following table shows the

available communication devices (USB, serial, infrared) according to

Operating Systems.

Operating Systems supported

Desktop PC Operating System Connection

Method

Windows 95 Windows 98 Windows 2000

Windows NT

USB No Yes Yes No

Serial Yes Yes Yes Yes

Infrared Yes Yes Yes No

USB Sync Sable

Follow the procedures below to connect between the desktop PC and

DOT 400 using the USB sync cable:

1. Connect the USB sync cable to the USB port of the desktop PC.

2. Connect the 24-pin connector of the other end to DOT 400.

Docking Cradle

Follow the procedures below to connect between the desktop PC and

DOT 400 using the docking cradle:

1. Connect the DC plug from the battery charger to the DC jack on

the cradle, and plug the battery charger into an electrical outlet.

2. Connect the USB cable from the cradle to a USB port on your

desktop PC.

3. Slide your DOT 400 into the cradle. The connection program of

DOT 400 and Microsoft ActiveSync of the desktop PC will start

automatically for their connection,

4. USB driver will be installed automatically, Otherwise You should

install USB driver manually referring to Install USB driver Part.

5. The New Partnership Wizard will appear on your desktop PC

to help you set up a partnership. The set up method is explained