User manual
Table Of Contents
- Product overview
- Features
- Installation environment
- Unpacking the TVR 10 and its accessories
- HDD capacity
- Back panel overview
- Connection diagram
- Control interfaces
- Controlling the TVR 10
- Front panel overview
- Using the mouse
- Using the IR remote control
- Using the Web browser
- Main menu overview
- Turning on the TVR 10
- Live mode
- Connecting the spot monitor
- Logging on
- Controlling a PTZ camera
- Manual recording
- Playing back video
- Archiving recorded files
- Turning off the TVR 10
- User settings
- Camera settings
- Display settings
- Recording settings
- Alarm settings
- Network settings
- PTZ settings
- Modifying the device name
- Restoring to factory defaults
- Managing the hard drive
- Acknowledging an alarm
- Rebooting the TVR 10
- Viewing logs
- Upgrade methods
- Upgrading with a USB flash memory
- Upgrading through the Web browser
- Setting up the wftp32 FTP server
- Upgrading using the FTP server
- Display interface
- PTZ interface
- Camera name position configure interface
- Area configure interface
- Text input interface
- Playlist interface
- User interface
- Menu defaults
- Network defaults
- Warranty information
- Contacting support
Chapter 5: Advanced setup
TruVision DVR 10 User Manual 57
4. Define the motion detection area.
Move the pointer or use the directional arrow buttons (Up, Down, Left, or Right) to
move the yellow pane to the zone you want to mask. Click to select that area for
motion detection. The yellow panes turn red, indicating an alarm will trigger if
motion is detected within this area. Drag the mouse or use the directional arrow
buttons to extend or shrink the motion detection area.
5. Click in the red area to save that area for motion detection and return to the
yellow pane to continue defining areas as shown in the figure below.
6. Repeat steps 4 to 6 for additional motion detection areas. You can set up four
masked areas on a screen.
7. To clear part of a motion detection area, move the yellow pane to the motion
detection area you want to delete and press REC. To clear all motion detection
zones, press #.
8. Click the mouse to return to the Camera Configuration screen.
To define the motion alarm response rules:
1. Display the Motion Detection Alarm Rules screen.
Click Motion Detection Rules to display the Motion Rules dialog screen as shown in
the figure below.