User manual

11
Alarm output is tangency output of
relay non-load, it can be used up
to AC220/10A by connecting the
load. The switch is automatically
turned on when the sensor works
and it is possible to cancel by
using the controller after a limited
time
The sensor
Can be connected maximum 4 channels and the camera
can be moved automatically to the point by preset mode,
DATA
Can be processed by RS485 or RS422 and use parallel connection to use a large quantity of
cameras. ( Even if it must be used 2-twist paired cable in use of RS422, the terminal port
which was connected with R485 cable port with 1-pair cable when it is not necessary to take
a return data from camera