User manual

xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch User Manual
148
Using a 10.xxx.xxx.xxx IP address notation, the above example would give six network addresses and six subnets.
Any IP address from the allowed range of IP addresses for each subnet can be chosen as an IP address for an IP interface
on the switch.
For this example, we have chosen the next IP address above the network address for the IP interface’s IP Address:
VLAN Name VID Network Number IP Address
System (default) 1 10.32.0.0 10.32.0.1
Engineer 2 10.64.0.0 10.64.0.1
Marketing 3 10.96.0.0 10.96.0.1
Finance 4 10.128.0.0 10.128.0.1
Sales 5 10.160.0.0 10.160.0.1
Backbone 6 10.192.0.0 10.192.0.1
Table 6- 5. VLAN Example - Assigned IP Interfaces
The six IP interfaces, each with an IP address (listed in the table above), and a subnet mask of 255.224.0.0 can be entered
into the Setup IP Interface window.
To setup IP Interfaces on the Switch:
Go to the Configuration folder, and click on the Layer 3 IP Networking folder, and then click on the IP Interfaces
Table link to open the following dialog box:
Figure 6- 112. IP Interface Settings window
To setup a new IP interface, click the Add button. To edit an existing IP Interface entry, click on an entry under the
Interface Name heading. Both actions will result in the same screen to configure, as shown below.
Figure 6- 113. IP Interface Settings – Add