User manual

xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch User Manual
130
The following window is the CPU Access Rule Table for IPv6.
Figure 6- 90. CPU Access Rule Table (IPv6)
To create a new rule set for an access profile click the Add button. A new window is displayed. To remove a previously
created rule, click the corresponding
button. The following window is used for the CPU IP Rule configuration.
Figure 6- 91. CPU Access Rule Configuration (IPv6)
The following parameters may be viewed or modified:
Parameter Description
Profile ID
This is the identifier number for this profile set.
Mode
Select Permit to specify that the packets that match the access profile are forwarded
by the Switch, according to any additional rule added (see below).
Select Deny to specify that packets that match the access profile are not forwarded
by the Switch and will be filtered.
Access ID
Type in a unique identifier number for this access. This value can be set from 1 – 5.
Type
Selected profile based on Ethernet (MAC Address), IP address, Packet Content or
IPv6.
• Ethernet instructs the Switch to examine the layer 2 part of each packet
header.
• IP instructs the Switch to examine the IP address in each frame's header.
• Packet Content Mask instructs the Switch to examine the packet header.
• IPv6 instructs the Switch to examine the IPv6 part of each packet header.