User manual

xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch User Manual
125
Parameters Description
Profile ID
This is the identifier number for this profile set.
Mode
Select Permit to specify that the packets that match the access profile are forwarded
by the Switch, according to any additional rule added (see below).
Select Deny to specify that packets that match the access profile are not forwarded
by the Switch and will be filtered.
Access ID
Type in a unique identifier number for this access and priority. This value can be set
from 1 - 5.
Type
Selected profile based on Ethernet (MAC Address), IP address, Packet Content or
IPv6.
• Ethernet instructs the Switch to examine the layer 2 part of each packet
header.
• IP instructs the Switch to examine the IP address in each frame's header.
• Packet Content Mask instructs the Switch to examine the packet header.
• IPv6 instructs the Switch to examine the IPv6 part of each packet header.
VLAN Name
Allows the entry of a name for a previously configured VLAN.
Source MAC
Source MAC Address - Enter a MAC Address for the source MAC address.
Destination MAC
Destination MAC Address - Enter a MAC Address mask for the destination MAC
address.
802.1p (0-7)
Enter a value from 0-7 to specify that the access profile will apply only to packets with
this 802.1p priority value.
Ethernet Type
Specifies that the access profile will apply only to packets with this hexadecimal
802.1Q Ethernet type value (hex 0x0-0xffff) in the packet header. The Ethernet type
value may be set in the form: hex 0x0-0xffff, which means the user may choose any
combination of letters and numbers ranging from a-f and from 0-9999.
To view the settings of a previously correctly configured rule, click in the CPU Access Rule Table to view the
following screen:
Figure 6- 83. CPU Access Rule Display (Ethernet).
The following window is the CPU Access Rule Table for IP.