User manual

xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch User Manual
108
Parameters Description
Profile ID
This is the identifier number for this profile set.
Mode
Select Permit to specify that the packets that match the access profile are forwarded by
the Switch, according to any additional rule added (see below).
Select Deny to specify that packets that match the access profile are not forwarded by the
Switch and will be filtered.
Select Mirror to specify that packets that match the access profile are mirrored to a port
defined in the Port Mirroring window. Port Mirroring must be enabled and a target port
must be set. Remember, Port Mirroring cannot cross-box, that is they cannot span across
switches in a switch stack.
Access ID
Type in a unique identifier number for this access. This value can be set from 1 - 65535.
• Auto Assign – Checking this field will instruct the Switch to automatically assign
an Access ID for the rule being created.
Type
Selected profile based on Ethernet (MAC Address), IP address, Packet Content Mask or
IPv6.
• Ethernet instructs the Switch to examine the layer 2 part of each packet header.
• IP instructs the Switch to examine the IP address in each frame's header.
• Packet Content Mask instructs the Switch to examine the packet header.
• IPv6 instructs the Switch to examine the IPv6 part of each packet header.
Priority (0-7)
This parameter is specified to re-write the 802.1p default priority previously set in the
Switch, which is used to determine the CoS queue to which packets are forwarded to.
Once this field is specified, packets accepted by the Switch that match this priority are
forwarded to the CoS queue specified previously by the user.
Replace priority with − Click the corresponding box to re-write the 802.1p default priority of
a packet to the value entered in the Priority field, which meets the criteria specified
previously in this command, before forwarding it on to the specified CoS queue.
Otherwise, a packet will have its incoming 802.1p user priority re-written to its original
value before being forwarded by the Switch.
For more information on priority queues, CoS queues and mapping for 802.1p, see the
QoS section of this manual.
Replace DSCP (0-
63)
Select this option to instruct the Switch to replace the DSCP value (in a packet that meets
the selected criteria) with the value entered in the adjacent field.
VLAN Name
Allows the entry of a name for a previously configured VLAN.
Source MAC
Source MAC Address - Enter a MAC Address for the source MAC address.
Destination MAC
Destination MAC Address - Enter a MAC Address mask for the destination MAC address.
802.1p (0-7)
Enter a value from 0-7 to specify that the access profile will apply only to packets with this
802.1p priority value.
Ethernet Type
Specifies that the access profile will apply only to packets with this hexadecimal 802.1Q
Ethernet type value (hex 0x0-0xffff) in the packet header. The Ethernet type value may be
set in the form: hex 0x0-0xffff, which means the user may choose any combination of
letters and numbers ranging from a-f and from 0-9999.
Port
The Access Rule may be configured on a per-port basis by entering the port number of
the switch in the switch stack into this field When a range of ports is to be configured the