User manual

xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch User Manual
107
Class
Checking this field will instruct the Switch to examine the class field of the IPv6
header. This class field is a part of the packet header that is similar to the Type of
Service (ToS) or Precedence bits field in IPv4.
Flowlabel
Checking this field will instruct the Switch to examine the flow label field of the IPv6
header. This flow label field is used by a source to label sequences of packets such
as non-default quality of service or real time service packets.
Source IPv6 Mask
The user may specify an IP address mask for the source IPv6 address by checking
the corresponding box and entering the IP address mask.
Destination IPv6
Mask
The user may specify an IP address mask for the destination IPv6 address by
checking the corresponding box and entering the IP address mask.
Click Apply to implement changes made.
To establish the rule for a previously created Access Profile:
To configure the Access Rule for Ethernet, open the Access Profile Table and click Modify for an Ethernet entry. This
will open the following screen:
Figure 6- 63. Access Rule Table
To remove a previously created rule, select it and click the
button. To add a new Access Rule, click the Add button:
Figure 6- 64. Access Rule Configuration window - Ethernet.
To set the Access Rule for Ethernet, adjust the following parameters and click Apply.