User manual

xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch User Manual
106
Offset
This field will instruct the Switch to mask the packet header beginning with the offset value
specified:
• value (0-15) - Enter a value in hex form to mask the packet from the beginning
of the packet to the 15th byte.
• value (16-31) – Enter a value in hex form to mask the packet from byte 16 to
byte 31.
• value (32-47) – Enter a value in hex form to mask the packet from byte 32 to
byte 47.
• value (48-63) – Enter a value in hex form to mask the packet from byte 48 to
byte 63.
• value (64-79) – Enter a value in hex form to mask the packet from byte 64 to
byte 79.
Click Apply to implement changes made.
The page shown below is the IPv6 configuration window.
Figure 6- 62. Access Profile Configuration (IPv6) window
The following parameters can be set, for IP:
Parameter Description
Profile ID (1-8)
Type in a unique identifier number for this profile set. This value can be set from 1 - 8.
Type
Select profile based on Ethernet (MAC Address), IP address, Packet Content Mask or
IPv6. This will change the menu according to the requirements for the type of profile.
• Select Ethernet to instruct the Switch to examine the layer 2 part of each
packet header.
• Select IP to instruct the Switch to examine the IP address in each frame's
header.
• Select Packet Content Mask to specify a mask to hide the content of the
packet header.
• Select IPv6 to instruct the Switch to examine the IPv6 part of each packet
header.