User manual

xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch User Manual
105
The page shown below is the Packet Content Mask configuration window.
Figure 6- 61. Access Profile Configuration (Packet Content Mask) window
This screen will aid the user in configuring the Switch to mask packet headers beginning with the offset value specified.
The following fields are used to configure the Packet Content Mask:
Parameter Description
Profile ID (1-8)
Type in a unique identifier number for this profile set. This value can be set from 1 - 8.
Type
Select profile based on Ethernet (MAC Address), IP address, packet content mask or
IPv6. This will change the menu according to the requirements for the type of profile.
• Select Ethernet to instruct the Switch to examine the layer 2 part of each packet
header.
• Select IP to instruct the Switch to examine the IP address in each frame's
header.
• Select Packet Content Mask to specify a mask to hide the content of the packet
header.
• Select IPv6 to instruct the Switch to examine the IPv6 part of each packet
header.