User manual

xStack DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch
To establish the rule for a previously created Access Profile:
To configure the Access Rule for Ethernet, open the Access Profile Table and click Modify for an Ethernet entry. This will
open the following screen:
Figure 9- 9. Access Rule Table
To remove a previously created rule, select it and click the button. To add a new Access Rule, click the Add Rule button:
Figure 9- 10. Access Rule Configuration window - Ethernet
To set the Access Rule for Ethernet, adjust the following parameters and click Apply.
Parameter Description
Profile ID
This is the identifier number for this profile set.
Mode
Select Permit to specify that the packets that match the access profile are forwarded by the
Switch, according to any additional rule added (see below).
Select Deny to specify that packets that do not match the access profile are not forwarded by the
Switch and will be filtered.
Access ID
Type in a unique identifier number for this access. This value can be set from 1 - 128.
Auto Assign – Checking this field will instruct the Switch to automatically assign an Access ID
181