Systems Switch User Manual
Table Of Contents
- Intended Readers
- Notes, Notices, and Cautions
- Introduction
- Installation
- Connecting the Switch
- Introduction to Switch Management
- Web-based Switch Configuration
- Introduction
- Appendix A – Technical Specifications
- Appendix B – Cables and Connectors
- Appendix C – Module Specs and Cable Lengths
- Appendix D – Glossary
- Warranties
- Technical Support
- International Offices
xStack
®
DGS-3200 Series Layer 2 Gigabit Ethernet Managed Switch
27
Connecting To Network Backbone or Server
The combo SFP ports and the 1000BASE-T ports are ideal for uplinking to a network backbone, server or server farm. The copper
ports operate at a speed of 1000, 100 or 10Mbps in full or half duplex mode. The fiber-optic ports can operate at both 100Mbps
and 1000Mbps in full duplex mode.
Connections to the Gigabit Ethernet ports are made using a fiber-optic cable or Category 5e copper cable, depending on the type
of port. A valid connection is indicated when the Link LED is lit.
Figure 3- 5. Uplink connection to a server, PC, or switch stack
Figure 3- 6. Uplink connection to a server, PC, or switch stack