Systems Switch User Manual
Table Of Contents
- Intended Readers
- Notes, Notices, and Cautions
- Introduction
- Installation
- Connecting the Switch
- Introduction to Switch Management
- Web-based Switch Configuration
- Introduction
- Appendix A – Technical Specifications
- Appendix B – Cables and Connectors
- Appendix C – Module Specs and Cable Lengths
- Appendix D – Glossary
- Warranties
- Technical Support
- International Offices
xStack
®
DGS-3200 Series Layer 2 Gigabit Ethernet Managed Switch
12
Features
The list of features below highlights the significant features of the Switch.
• IEEE 802.3 compliant
• IEEE 802.3z compliant
• IEEE 802.3x Flow Control in full-duplex compliant
• IEEE 802.3u compliant
• IEEE 802.3ab compliant
• IEEE 802.1p Priority Queues
• IEEE 802.3ad Link Aggregation Control Protocol support
• IEEE 802.1X Port-based and Host-based Access Control
• IEEE 802.1Q VLAN
• IEEE 802.1D Spanning Tree, IEEE 802.1w Rapid Spanning Tree and IEEE 802.1s Multiple Spanning Tree support
• Support jumbo frame to 10K Bytes
• Access Control List (ACL) support
• ISM VLAN support
• Egress filter supported to drop DLF/multicast packets to zero
• DHCP local relay support
• Single IP Management support
• Access Authentication Control utilizing TACACS, XTACACS, TACACS+ and RADIUS protocols
• Supports Multiple Authentication
• Dual Image Firmware
• Power saving mode support
• Broadcast Ping support
• Dual configuration support
• Simple Network Time Protocol support
• System Log support
• SMTP Log support
• High performance switching engine performs forwarding and filtering at full wire speed up to 20Gbps (DGS-3200-
10)/32Gbps (DGS-3200-16)
• Full- and half-duplex for all gigabit ports. Full duplex allows the switch port to simultaneously transmit and receive data. It
only works with connections to full-duplex-capable end stations and switches. Connections to a hub must take place at half-
duplex.
•
Support broadcast storm control
• Loopback Detection (LBD) v4.0 Trap support
• Non-blocking store and forward switching scheme capability to support rate adaptation and protocol conversion
• Supports Egress/Ingress bandwidth control
• Efficient self-learning and address recognition mechanism enables forwarding rate at wire speed
• Address table: Supports up to 8K (DGS-3200-10)/16K (DGS-3200-16) MAC addresses per device
• Supports a packet buffer of up to 1 Mbits (DGS-3200-10)/6 Mbits (DGS-3200-16)
• Port Trunking with flexible load distribution and fail-over function