Systems Network Router User Manual

DSL-G604T Generation II ADSL2+ Wireless Modem Router
Page 46 of 110 www.dlink.com.au
ATM VC Settings
ATM VC settings can be configured for all connection types in the WAN configuration menu of the Home
directory.
ATM VC Settings in WAN Settings menu
The table below describes the ATM VC settings used to configure a PPPoE or PPPoA connection for an ADSL
account.
ATM VC Parameters Description
PVC The Router supports using up to eight multiple virtual connections. This window allows
the user to configure WAN settings for all the available connections (see instructions
below on how to set up Multiple Virtual Connections). Use the PVC drop-down menu
to select the connection (Pvc0 to Pvc7) you want to configure. Since most users will
use only a single connection, the default setting
Pvc0 can be used for any changes
made to the WAN settings.
VPI The Virtual Path Identifier is used with the VCI to define a dedicated circuit on the
ATM network portion of the connection to the Internet and WAN. Most users will not
need to change this setting.
VCI The Virtual Channel Identifier is used with the VPI to define a dedicated circuit on the
ATM network portion of the connection to the Internet and WAN. Most users will not
need to change this setting.
Virtual Circuit As with the PVC setting, this is mainly for use by clients who are configuring the
Router for multiple virtual connections. Use this to enable or disable the PVC you are
currently configuring. By default, the Pvc0 is
Enabled and the remaining PVCs are
disabled.