User's Manual
Table Of Contents
- Package Contents
- Installation
- Configuration
- Web-based Configuration Utility
- Setup Wizard
- Internet Setup
- Wireless Setup
- Network Settings
- DHCP Server Settings
- Port Forwarding
- QoS Engine
- QoS Engine
- Network Filter
- Firewall & DMZ
- Advanced Wireless
- Advanced Network
- IPv6 Routing
- Device Administration
- Save and Restore
- System Check
- Schedules
- Syslog
- Device Info
- Log
- Statistics
- Internet Sessions
- Wireless
- Help
- Web-based Configuration Utility
- Wireless Security
- Connect to a Wireless Network
- Setting Up Wi-Fi Protection
- (WCN 2.0 in Windows Vista)
- Changing the Computer Name and Joining a Workgroup
- Configuring the IP Address in Vista
- Setting Up a Connection or Network Wirelessly
- Connecting to a Secured Wireless Network (WEP, WPA-PSK & WPA2-PSK)
- Connecting to an Unsecured Wireless Network
- Troubleshooting
- Wireless Basics
- Networking Basics
- Technical Specifications
49D-Link RG-DLINK-WBR2320 User Manual
Section 4 - Security
Congure WPA-PSK and WPA2-PSK
It is recommended to enable encryption on your wireless Router before your wireless network adapters. Please establish
wireless connectivity before enabling encryption. Your wireless signal may degrade when enabling encryption due to
the added overhead.
1. Log into the web-based conguration by opening a web browser
and entering the IP address of the router (192.168.0.1). Click on
Wireless Setup on the left side.
2. Next to Security Mode, select Enable WPA Only Wireless
Security (enhanced) or Enable WPA2 Only Wireless Security
(enhanced).
3. Next to Cipher Mode, select TKIP, AES, or Both.
4. Next to PSK/EAP, select PSK.
5. Next to Network Key, enter a key (passphrase). The key is an
alpha-numeric password
between 8 and 63 characters long. The password can
include symbols (!?*&_) and spaces. Make sure you enter
this key exactly the same on all other wireless clients.
6. Click Save Settings to save your settings. If you are conguring
the Router with a wireless adapter, you will lose connectivity until you enable WPA-PSK or WPA2-PSK on your
adapter and enter the same passphrase as you did on the Router.