User's Manual
Table Of Contents
- Package Contents
- Installation
- Configuration
- Web-based Configuration Utility
- Setup Wizard
- Internet Setup
- Wireless Setup
- Network Settings
- DHCP Server Settings
- Port Forwarding
- QoS Engine
- QoS Engine
- Network Filter
- Firewall & DMZ
- Advanced Wireless
- Advanced Network
- IPv6 Routing
- Device Administration
- Save and Restore
- System Check
- Schedules
- Syslog
- Device Info
- Log
- Statistics
- Internet Sessions
- Wireless
- Help
- Web-based Configuration Utility
- Wireless Security
- Connect to a Wireless Network
- Setting Up Wi-Fi Protection
- (WCN 2.0 in Windows Vista)
- Changing the Computer Name and Joining a Workgroup
- Configuring the IP Address in Vista
- Setting Up a Connection or Network Wirelessly
- Connecting to a Secured Wireless Network (WEP, WPA-PSK & WPA2-PSK)
- Connecting to an Unsecured Wireless Network
- Troubleshooting
- Wireless Basics
- Networking Basics
- Technical Specifications
8D-Link RG-DLINK-WBR2320 User Manual
Section 2 - Installation
If you are connecting the D-Link router to another router to use as a wireless access point and/or switch, you will have
to do the following before connecting the router to your network:
• Disable UPnP
™
• Disable DHCP
• Change the LAN IP address to an available address on your network. The LAN ports on the router cannot
accept a DHCP address from your other router.
To connect to another router, please follow the steps below:
1. Plug the power into the router. Connect one of your computers to the router (LAN port) using an Ethernet cable.
Make sure your IP address on the computer is 192.168.0.xxx (where xxx is between 2 and 254). Please see the
Networking Basics section for more information. If you need to change the settings, write down your existing settings
before making any changes. In most cases, your computer should be set to receive an IP address automatically in
which case you will not have to do anything to your computer.
2. Open a web browser and enter http://192.168.0.1 and press Enter. When the login window appears, set the user
name to admin and leave the password box empty. Click OK to continue.
3. Click on Advanced and then click Advanced Network. Uncheck the Enable UPnP checkbox. Click Save Settings
to continue.
4. Click Setup and then click Network Settings. Uncheck the Enable DHCP Server server checkbox. Click Save
Settings to continue.
5. Under Router Settings, enter an available IP address and the subnet mask of your network. Click Save Settings to
save your settings. Use this new IP address to access the conguration utility of the router in the future. Close the
browser and change your computer’s IP settings back to the original values as in Step 1.
Connect to Another Router