User manual
78D-Link DAP-1522 User Manual
Section 4 - Security
Configure WEP (Bridge Mode)
It is recommended to enable encryption on your wireless access point before your wireless network adapters. Please
establish wireless connectivity before enabling encryption. Your wireless signal may degrade when enabling encryption
due to the added overhead.
1. Log into the web-based conguration by opening a web browser and entering the IP address of the bridge
(192.168.0.50). Click on Setup and then click Wireless Settings.
2. For Security Mode in the Wireless Security Mode section,
select WEP.
3. Next to WEP Key Length in the WEP section, select both the type
of input (hexidecimal or ASCII) and the level of encryption (64-
bit or 128-bit). Hex - (recommended) Letters A-F and numbers 0-9
are valid.
4. For the Default WEP Key and the rst selection on the drop-down menu, WEP Key 1. Enter a WEP key that you
create in the WEP Key value and Verify WEP Key value elds. Make sure you enter this key exactly on all your
wireless devices. You may enter up to 4 different keys using the Default WEP Key drop-down menu.
5. For Authentication, select Open or Shared Key.
6. Click Save Settings to save your settings. If you are conguring the access point with a wireless adapter, you will lose
connectivity until you enable WEP on your adapter and enter the same WEP key as you did on the access point.