User manual

DIR-620 Multifunction Wireless Router Supporting GSM, CDMA, WiMAX
with Built-in 4-port Switch
User Manual
Configuring via Web-based Interface
Configuring PPPoE Interface
This interface type is available for the WAN and WIMAX interfaces.
Figure 21. Configuring the WAN interface.
Parameter Description
Interface type The type of configuration for this interface (PPPoE).
MAC-address
Displayed for the WAN interface only.
This parameter is mandatory, if your ISP uses MAC address binding. In
the field, enter the MAC address registered by your ISP upon
concluding the agreement. You can click the Client MAC-address
button to set the MAC address of the network interface card (of the
computer that is being used to configure the router at the moment) as
the MAC address of the WAN interface.
Start
Select a radio button to enable or disable the interface auto-start upon
the boot-up of the router.
Click the Change button.
When you select this type for the WAN or WIMAX interface, it gets IP address 0.0.0.0. Then, if
needed, proceed to the Net > P-t-p interfaces page and create a PPPoE interface with parameters
provided by your ISP.
Page 31 of 100