Installation guide

DIR-620 Quick Installation Guide

Wired Connection

If your ISP uses MAC address binding, assign the MAC address registered

by your ISP upon concluding the agreement to the WAN interface. To

assign the MAC address of the network interface card (of the computer

that is being used to configure the router), click the Client MAC-

address button.

Configuring Static IP or Dynamic IP (DHCP) Connection

1. Proceed to the Net > Network interfaces page.

2. Follow the WAN link.

3. Select a needed value from the Interface type drop-down list.

4. For a Static IP connection, populate the fields in accordance with data

provided by your ISP.

5. Select a method for starting this interface (select the Auto choice to

enable the interface auto-start upon the boot-up of the router, or select the

Manual choice to start the interface manually in the web-based

interface).

6. Click the Change button.

Configuring PPTP or L2TP Connection

1. Proceed to the Net > Network interfaces page.

2. Follow the WAN link.

3. Select a needed value from the Interface type drop-down list (for the

static IP address you also need to populate the IP address, Mask and

Default gateway fields).

4. Select a method for starting this interface (select the Auto choice to

enable the interface auto-start upon the boot-up of the router, or select the

Manual choice to start the interface manually in the web-based

interface).

5. Click the Change button.

6. Proceed to the Net > P-t-p interfaces page.