Systems Network Router User Manual

88 © 2001- 2008 D-Link Corporation. All Rights Reserved.
Wired Configuration Guide
Figure 41. VRRP Example Network Configuration
Example 1: Configuring VRRP on the Switch as a Master Router
Enable routing for the switch. IP forwarding is then enabled by default.
config
ip routing
exit
Configure the IP addresses and subnet masks for the port that will participate in the protocol.
config
interface 0/2
routing
ip address 192.150.2.1 255.255.255.0
exit
Enable VRRP for the switch.
config
ip vrrp
exit
0ORT

6IRTUAL2OUTER)$
6IRTUAL!DDR
0ORT

6IRTUAL2OUTER)$
6IRTUAL!DDR
(OSTS
5NIFIED3WITCHACTING
AS2OUTER
,AYER3WITCH
5NIFIED3WITCHACTING
AS2OUTER