Systems Network Router User Manual

80 © 2001- 2008 D-Link Corporation. All Rights Reserved.
Wired Configuration Guide
Using the Web Interface to Configure Routing
Use the following screens to perform the same configuration using the Graphical User
Interface:
To enable routing for the switch, as shown in Example 1. Enabling routing for the Switch, use
the LAN> L3 Features> IP > Configuration page.
Figure 33. IP Configuration
To configure routing on each interface, as shown in Example 2. Enabling Routing for Ports on
the Switch, use the LAN> L3 Features > IP > Interface Configuration page.
Figure 34. IP Interface Configuration